F Ball - F40 Styccobond High Tack Adhesive - Dual Bond System

each
Bulk Buy Discount
£63.34
In stock
SKU
F Ball - F40 Styccobond High Tack Adhesive - Dual Bond System
  • Available for Next Day Delivery
  • FREE Delivery when you spend over £125

F Ball - F40 Styccobond High Tack Adhesive - Dual Bond System

STYCCOBOND F40 is a solvent free synthetic polymer emulsion adhesive, developed to provide a peelable bond for release underlays. It can also be used as a permanent or release bond adhesive when fixing carpets. It is water based and dries to form a transparent, permanently tacky coating.

The type of bond achieved is dependent on when the floorcovering is laid into the adhesive.
Laying the floorcovering into the adhesive once it has dried enables the underlay or carpet to be lifted when required, without significant damage to either floorcovering or subfloor. Laying the floorcovering into wet adhesive gives a permanent bond. It is suitable for use over normal underfloor heating installations. 

STYCCOBOND F40 can be used for securing a wide range of carpets which include those with felt, secondary, unitary and many other backings. It is also suitable for fixing certain release underlays which have been specifically developed for release bonding.

STYCCOBOND F40 can be applied to STOPGAP smoothing underlayments, structurally sound, smooth, dry subfloors of concrete and sand/cement screed, plywood, flooring grade chipboard and hardboard.
Sound flooring grade asphalt must be skimmed with a minimum of 3mm of the appropriate STOPGAP smoothing underlayment. 

STYCCOBOND F40 can be applied directly to non-absorbent subfloors such as STOPGAP Waterproof Surface Membranes, Corrosion Treated Steel, Terrazzo, and Granolithic Tiles.

Technical Information:

  • Appearance: Viscous Liquid
  • Colour: White
  • Drying Time (approx.): 40 minutes depending on temperature, humidity and absorbency of the subfloor
  • Coverage (approx.): 4m2 - 7m2 per litre with a 1.5mm x 5mm trowel OR 7m2 - 9m2 with a roller

    15 litres Tub = 60-105m2 with a 1.5mm x 5mm trowel
    15 litres Tub = 105-135m2 with a roller

    5 litres = 20-35m2 with a 1.5mm x 5mm trowel
    5 litres = 35-45m2 with a roller

    Note: Coverage rates will depend on the condition and absorbency of the subfloor

  • Available in 5ltr and 15ltr capacity

Application:

Peelable bond - carpets - Holding the notched trowel at an angle of 60°, apply the adhesive evenly to the subfloor. Allow the adhesive to dry completely to a clear tacky coating before laying the carpet. Following the carpet manufacturers instructions, lay the floorcovering and press from the centre outwards to exclude air and then apply pressure by rolling with a 68kg flooring roller, from end-to-end and side-to-side.

Peelable bond - underlays - Apply the adhesive to the subfloor using the notched trowel or paint roller as specified by the underlay manufacturer. Allow the adhesive to dry completely to a clear tacky coating before laying the underlay. Following the underlay manufacturers instructions, lay the material and press from the centre outwards to exclude air and then apply pressure using the STYCCOBOND Glyda or soft bristle broom to ensure overall adhesion. The carpet can then be permanently bonded to the underlay immediately, with the recommended adhesive using normal installation techniques.

Permanent bond - carpets - Holding the notched trowel at an angle of 60°, apply the adhesive evenly to the subfloor. Leave the adhesive open for 10 - 15 minutes before laying the carpet. Following the carpet manufacturers instructions, lay the floorcovering and press from the centre outwards to exclude air and then apply pressure by rolling with a 68kg flooring roller, from end to end and side to side. It may be necessary to re-roll the carpet 30 minutes later, depending on conditions, to ensure overall adhesion is maintained.

For any areas under question please consult the F Ball Technical team.

Precautions:

If a peelable bond is specified do not lay the underlay or carpet before the adhesive has completely dried as this will impair its release and may result in a permanent bond being formed. 

Not all carpets are suitable for use over release underlay systems, check with the carpet manufacturer before proceeding. Do not apply the adhesive too thinly as this will reduce adhesion.

We would suggest that carpets are best maintained using dry cleaning methods in preference to wet extraction, thus avoiding potential for damage to the adhesive bond caused by excessive use of cleaning fluids.

Tools:

STYCCOBOND 1.5mm x 5mm ‘V’ notched trowel or STYCCOBOND Paint Roller, F. Ball 68kg flooring roller, STYCCOBOND GLYDA. Tools should be cleaned with warm soapy water while the adhesive is still wet.

Storage:

Store between 5ºC and 30°C. Protect from frost.

Shelf Life:

12 months in unopened containers stored under good conditions.

Delivery Information

We aim to dispatch all orders within 2 working day of receipt. Occasionally public holidays, weekends, weather events, or extremely busy periods may result in extended delivery times. In these circumstances, we will endeavour to communicate with you about the delay and resolve and resulting issues.

Please note that we do not make delivery date promises, however:

- Orders placed before 1pm on a weekday will be processed the same day.

- Orders placed after 1pm on a weekday will be processed the following morning. 

- Orders placed after 1pm on Thursday will be processed and dispatched the following day and out for delivery the following Monday (if Next Day Delivery is selected).

- Orders placed after 1pm on Fridays will be processed and dispatched on the following Monday.

For more information about our Shipping & Delivery services click HERE

 

UK Mainland Delivery Options:

£0.00

Free Delivery: Applicable for orders of £125 excl. VAT and above
(Monday – Friday, excluding public holidays)

£0.00

Collect From Store: 41 Markfield Road, London N15 4QA
(Monday – Friday, 9am–5pm excluding public holidays)

£8.50

Standard Delivery: 3-5 Working Days
(Monday – Friday, excluding public holidays)

£15.00

Express Delivery: Next Working Day
(Monday – Friday, excluding public holidays)

Out Of Zone Delivery Surcharges:

Isle of Wight

£12.50 per item (3-5 Working Days)

Isles of Scilly

£12.50 per item (3-5 Working Days)

Northern Ireland

£25.00 per item (3-5 Working Days)

Western Isles

£25.00 per item (3-5 Working Days)

Shetland Isles

£30.00 per item (3-5 Working Days)

Orkney

£30.00 per item (3-5 Working Days)

Isle Of Man

£30.00 per item (3-5 Working Days)

Channel Islands

£30.00 per item

Republic of Ireland

Not Available

 

paypalconfidence