Description
F Ball F57 Styccobond Conductive Acrylic Adhesive – 15ltr tub
STYCCOBOND F57 is a solvent-free, fibre-filled acrylic conductive adhesive, which is designed to give a high bond strength, strong initial tack, a long open time and good plasticiser resistance. It is protected against biodegradation and is suitable for use over normal underfloor heating installations.
STYCCOBOND F57 can be used for securing a wide range of conductive/antistatic PVC floor coverings. It can be applied to STOPGAP smoothing underlayments, structurally sound, smooth, dry subfloors of concrete and sand/cement screed and flooring grade plywood.
STOPGAP Waterproof Surface Membranes, sound flooring grade asphalt and other non-absorbent surfaces must be skimmed with a minimum of 3mm of the appropriate STOPGAP smoothing underlayment.
Product Specifications & Key Features:
- Appearance: Viscous Liquid
- Colour: Grey
- OpenTime (approx.): Up to 45 minutes depending on temperature, humidity and absorbency of the subfloor
- Coverage (approx.): 4m² per litre using the 2mm x 6mm trowel
- 15 litres Tub = 60m²
- Note: Coverage rates will depend on the condition and absorbency of the subfloor
Application:
Holding the trowel at an angle of 60°, spread the adhesive evenly over an area of the subfloor that can be covered whilst the adhesive remains receptive and gives good transfer. Allow the adhesive to partially dry to a firm tack before laying the floor covering.
Following the floorcovering manufacturers laying instructions lay the floorcovering into the adhesive and press from the centre outwards to exclude air and ensure overall contact with the adhesive. Roll with the 68kg flooring roller, from end-to-end and side-to-side to ensure overall contact. Thirty minutes later when the floor has been completely covered roll as necessary to ensure overall contact is maintained.
For any areas under question please consult the F Ball Technical team.
Precautions:
Do not apply loads or move furniture on the floorcovering until the adhesive has fully set. Do not weld vinyl floor coverings until the adhesive has had sufficient time to develop a good bond, normally 24 hours.
Tools:
STYCCOBOND 2mm x 6mm “V” notched trowel, F. Ball 68kg flooring roller, Trimming knife. Tools should be cleaned with warm soapy water while the adhesive is still wet.
Storage:
Store between 5°C and 30°C. Protect from frost.
Shelf Life:
12 months in unopened containers stored under good conditions.