F Ball – F46 (5ltr) Pressure Sensitive Acrylic Adhesive

£50.24 /item (incl. VAT)

10 in stock

Total:
Only 10 items left in stock!
  • Available for Next Day & Saturday Delivery
  • No Minimum Order
  • Order yours before 1pm for same-day dispatch

Description

F Ball F46 Pressure Sensitive Acrylic Adhesive – 5ltr

STYCCOBOND F46 is a solvent-free acrylic polymer emulsion adhesive that dries to a permanently tacky film. It is used to reduce the incidence of trowel serrations shadowing through thin vinyl flooring and is designed to give a strong initial tack and a high bond strength. It is protected against biodegradation and is suitable for use over normal underfloor heating installations.

STYCCOBOND F46 can be used for securing a wide range of sheet and tile floor coverings.

STYCCOBOND F46 can also be applied to STOPGAP smoothing underlayments, structurally sound, smooth, dry subfloors of concrete and sand/cement screed, plywood, flooring grade chipboard and hardboard. Sound flooring grade asphalt must be skimmed with a minimum of 3mm of the appropriate STOPGAP smoothing underlayment.

STYCCOBOND F46 can be applied directly to STOPGAP Waterproof Surface Membranes and other non-absorbent subfloors where the surface finish is smooth enough to permit the installation of resilient floorcoverings.

Product Specifications & Key Features:

  • Appearance: Viscous Liquid
  • Colour: White
  • Available in 5ltr capacity
  • Drying Time (approx.): 40 minutes depending on temperature, humidity and absorbency of the subfloor
  • Coverage (approx.): 3 per litre with a 1.5mm x 3mm (A2) or 4 per litre with a STYCCOBOND fine notch (A1) or 5 per litre with 1.5mm x 5mm trowel:
    • 5 litres Tub = 25 with a 1.5mm x 3mm trowel
    • 5 litres Tub = 20 with a STYCCOBOND fine notch (A1)
    • 5 litres Tub = 15 with 1.5mm x 5mm trowel
  • Note: Coverage rates will depend on the condition and absorbency of the subfloor

Application:

Holding the trowel at an angle of 60°, spread the adhesive evenly over the subfloor. Following the floorcovering manufacturer’s laying instructions and using the guidelines given below, place the floorcovering into the adhesive and press from the centre outwards to exclude any air; then roll from end to end and side to side using the 68kg flooring roller. 1 to 4 hours later roll again in two directions

Absorbent surfaces – Apply the adhesive using a STYCCOBOND 1.5mm x 3mm (A2) or 1.5mm x 5mm ‘V’ notched trowel then immediately roll with a paint roller, which has been pre-wetted with adhesive, to obtain a smooth, uniform appearance, to minimise adhesive grin through. Alternatively, use the STYCCOBOND FINE NOTCH trowel. Floorcoverings can be placed into the adhesive immediately although it is advisable, when installing tiles, to leave the adhesive for approximately 10 minutes before placing the flooring, reducing the potential for sliding.

Non-absorbent surfaces – Apply the adhesive as previously described but allow the adhesive to dry to a firm tack before laying the floor covering. When installing vinyl tiles, apply the adhesive with a STYCCOBOND 1.5mm x 3mm (A2) or 1.5mm x 5mm ‘V’ notched trowel, then roll with a paint roller pre-wetted with the adhesive. Roll tiles immediately after placement into the dry adhesive film using a 68kg flooring roller. Alternatively, a STYCCOBOND FINE NOTCH (A1) trowel may be used if preferred.

Do not use the paint roller to extend the area covered by the adhesive, as this will reduce adhesion.

Note: When trowelling the adhesive directly onto cured STOPGAP Waterproof Surface Membranes, ensure that the membrane is not damaged or punctured by the trowel.

For any areas under question please consult the F Ball Technical team.

Precautions:

Do not apply loads or move furniture on the floorcovering until the adhesive has fully set. Do not weld vinyl floor coverings until the adhesive has had sufficient time to develop a good bond, normally 24 hours.

Tools:

1.5mm x 3mm (A2), STYCCOBOND Fine Notch (A1), or 1.5mm x 5mm ‘V’ notched trowel, F. Ball 68kg flooring roller, Trimming knife, STYCCOBOND paint roller. Tools should be cleaned with warm soapy water while the adhesive is still wet.

Storage:

Store between 5ºC and 30°C. Protect from frost.

Shelf Life:

12 months in unopened containers stored under good conditions.

Additional information

Weight 5.95 kg
Size

5 ltr

Appearance

Tub

Brand

F-Ball

Delivery Information

We aim to dispatch all orders within 1 working day of receipt. Occasionally public holidays, weekends, weather events, or extremely busy periods may result in extended delivery times. In these circumstances, we will endeavour to communicate with you about the delay and resolve and resulting issues.

Please note that we do not make delivery date promises, however:

  • Orders placed before 1 pm on a weekday will be processed the same day.
  • Orders placed after 1 pm on a weekday will be processed the following morning.
  • Orders placed after 1 pm on Thursday will be processed and dispatched the following day and out for delivery the following Monday (if Next Day Delivery is selected).
  • Orders placed after 1 pm on Fridays will be processed and dispatched on the following Monday.
  • Saturday Delivery – the cut-off day to receive an order on a Saturday of the same week is Thursday.

For more information about our Shipping, Delivery & Returns services click HERE


UK Mainland Delivery Options:

Free Collection from our London Store (See on the Map)
(Monday – Thursday: 9 am–5 pm; Friday: 9 am-1 pm excluding public holidays)
Location: 41 Markfield Road, London N15 4QA
£9.50 Standard Delivery: 3-5 Working Days
Applicable for all orders (apart from Pipe Covers & Samples)
(Monday – Friday, 9 am–5 pm excluding public holidays)
£18.00 Express Delivery: Next Working Day
For orders placed before 1 pm on a weekday
(Monday – Friday, 9 am–5 pm excluding public holidays)
£12.50 Bulky Item Surcharge Fee
For orders containing heavy & bulky items (Selected Underlays & Selected 2-metre width Coir Matting only)
(Monday – Friday, 9 am–5 pm excluding public holidays)
£20.00 Long Item Surcharge Fee
For orders of long-length items (2700mm Metal Door Bars & Laminate Scotia Beadings)
(Monday – Friday, 9 am–5 pm excluding public holidays)
£65.00 Saturday Delivery
(Saturday only, 8 am-1 pm excluding public holidays)

Out-Of-Zone Locations

Unfortunately, due to courier restrictions, we do not deliver to the locations listed below:
– Isle of Wight, Isles of Scilly, Western Isles, Shetland Isles, Orkney, Isle Of Man, Channel Islands, Northern Ireland, Republic of Ireland

In addition, we do not deliver to any locations with the postcodes listed below:
– IV27, IV40 -> IV49, IV51 -> IV56
– KA27, KA28
– PA28, PA29, PA40 -> PA49, PA60 -> PA80
– PH39 -> PH44

Customer Reviews

Based on 1 review
100%
(1)
0%
(0)
0%
(0)
0%
(0)
0%
(0)
s
simon h.
Flooring adhesive

Good price, quick delivery A+