F Ball - F84 (5kg) Styccobond Two Part Flooring Adhesive

each
Bulk Buy Discount
£51.43
In stock
SKU
F Ball - F84 (5kg)
  • 2 items +    £48.86
  • 5 items +    £46.28
 
  • Available for Next Day Delivery
  • FREE Delivery when you spend over £100

F Ball - F84 (5kg) Styccobond Two Part Flooring Adhesive

STYCCOBOND F84 is a two-part reactive epoxy adhesive designed for installing a wide range of sheet floorcoverings onto STOPGAP ISOLATOR MEMBRANE and other suitable substrates. It is ideal for use in areas that are subject to surface water and areas that are heavily trafficked. When cured the adhesive is resistant to water, oil and grease. Although it is suitable for outdoor use it is not intended to be used as, or a substitute for a waterproof surface membrane. 

STYCCOBOND F84 can be used for securing a wide range of vinyl and rubber floorcoverings, sheet linoleum and textile floorcoverings. 

STYCCOBOND F84 can be applied to STOPGAP smoothing underlayments, structurally sound, smooth, dry subfloors of concrete and sand/cement screed, plywood, flooring grade chipboard and hardboard.

STOPGAP Waterproof Surface Membranes, sound flooring grade asphalt and other non-absorbent surfaces must be skimmed with a minimum of 3mm of the appropriate STOPGAP smoothing underlayment.

Technical Information:

  • Appearance: Creamy Liquid
  • Colour: Light beige when mixed
  • Pot Life: Up to 20 minutes depending on temperature, humidity and absorbency of the subfloor
  • Working Time (Approx.): 1 hour at 20°C
  • Cure Time: At 20°C will allow foot traffic in 12 hours and normal use after 5 days. Avoid heavy point loads until the adhesive has fully cured – approximately 7 days
  • Coverage Rates (approx.): 3m2 per kg using a 1.5mm x 5mm trowel or 2m2 per kg using a 2mm x 6mm trowel. The resin and hardener are supplied in the correct quantities for mixing without measuring.
    5kg kit = 15m2 with a 1.5mm x 5mm trowel

    5kg kit = 10m2 with a 2mm x 6mm trowel
    Note: Coverage rates will depend on the condition and absorbency of the subfloor.


Application:

Floorcoverings must be laid and allowed to flatten, then cut to fit before mixing the adhesive. Holding the trowel at an angle of 60°, spread the adhesive evenly to an area that can be covered within the working time of the adhesive. Immediately lay the floorcovering into the wet adhesive, pressing from the centre outwards to exclude air. Roll to ensure overall contact with the adhesive. 

Under certain circumstances, it may be necessary to apply weights to some floorcoverings to maintain contact until the adhesive has set - about 12 hours. 

When laying floorcoverings with deeply profiled or studded backings, apply sufficient adhesive to ensure that the voids are filled when the floorcovering is laid into the adhesive. This will result in a lower coverage figure than that quoted above. The open time of the adhesive is dependent on temperature, humidity and absorbency of the subfloor. 

For any areas under question please consult the F Ball Technical team.

Precautions:

Mix only in full packs as mixing ratios are critical. Do not apply loads or move furniture on the floorcovering until the adhesive has set. 

Note: At lower temperatures, less than 10°C, the adhesive becomes significantly more difficult to mix by hand and apply. To overcome this, material should be conditioned at temperatures greater than 15°C and applied where the subfloor temperature is greater than 15°C. This will significantly ease the use of this adhesive.

Tools:

STYCCOBOND 1.5mm x 5mm ‘V’ notched trowel for smooth backed floorcoverings. STYCCOBOND 2mm x 6mm ‘V’ notched trowel for textile or floorcoverings with a profiled backing. F. Ball 68kg flooring roller. Clean tools with STYCCOCLEAN C141 floor cleaner immediately after use.

Storage:

Store between 5°C and 30°C. Protect from frost.

Shelf Life:

12 months in unopened containers and stored under good conditions.

Delivery Information

We aim to dispatch all orders within 2 working day of receipt. Occasionally public holidays, weekends, weather events, or extremely busy periods may result in extended delivery times. In these circumstances, we will endeavour to communicate with you about the delay and resolve and resulting issues.

Please note that we do not make delivery date promises, however:

- Orders placed before 1pm on a weekday will be processed the same day.

- Orders placed after 1pm on a weekday will be processed the following morning. 

- Orders placed after 1pm on Thursday will be processed and dispatched the following day and out for delivery the following Monday (if Next Day Delivery is selected).

- Orders placed after 1pm on Fridays will be processed and dispatched on the following Monday.

For more information about our Shipping & Delivery services click HERE

UK Mainland Delivery Options:

£0.00

Free Delivery: Applicable for orders of £100 excl. VAT and above
(Monday – Friday, excluding public holidays)

£0.00

Collect From Store: 41 Markfield Road, London N15 4QA
(Monday – Friday, 9am–5pm excluding public holidays)

£7.50

Standard Delivery: 3-5 Working Days
(Monday – Friday, excluding public holidays)

£12.50

Express Delivery: Next Working Day
(Monday – Friday, excluding public holidays)

Out Of Zone Delivery Surcharges:

Isle of Wight

£12.50 per item (3-5 Working Days)

Isles of Scilly

£12.50 per item (3-5 Working Days)

Northern Ireland

£25.00 per item (3-5 Working Days)

Western Isles

£25.00 per item (3-5 Working Days)

Shetland Isles

£30.00 per item (3-5 Working Days)

Orkney

£30.00 per item (3-5 Working Days)

Isle Of Man

£30.00 per item (3-5 Working Days)

Channel Islands

£30.00 per item

Republic of Ireland

Not Available

 

paypalconfidence